Wipers and Washers
Windshield wipers
Note: Fully defrost the windshield in icy conditions before turning on the windshield wipers.
Note: Make sure the windshield wipers are switched off before entering a car wash.
Note: Clean the windshield and wiper blades if they begin to leave streaks or smears. If that does not resolve the issue, install new wiper blades.
Note: Do not operate the wipers on a dry windshield. This may scratch the glass, damage the wiper blades or cause the wiper motor to burn out.
Always use the windshield washers before wiping a dry windshield.

Rotate the end of the control away from you to increase the speed of the wipers. Rotate toward you to decrease the speed of the wipers.
Press the stalk down and release for a single swipe of the wipers.
Speed Dependent Wipers (If Equipped)
When your vehicle speed increases, the interval between wipes will decrease when intermittent wipe is selected.
See also:
Floor mats
WARNING: Always use floor mats that are designed to fit the footwell of
your vehicle. Only use floor mats that leave the pedal area unobstructed. Only use
floor mats that are firmly secured to r ...
Safety canopy curtain airbags
WARNING: Do not place objects or mount equipment on or near the headliner
at the siderail that may come into contact with a deploying curtain airbag. Failure
to follow these instructions may incre ...
Reverse sensing system (if equipped)
The reverse sensing system (RSS) sounds a tone to warn the driver of obstacles
near the rear bumper when R (Reverse) is selected and the vehicle is moving at speeds
less than 3 mph (5 km/h). The s ...
