Windshield washers

Note: Do not operate the wipers on a dry windshield. This may scratch the glass, damage the wiper blades or cause the wiper motor to burn out.

Always use the windshield washer before wiping a dry windshield.

Note: Do not operate the washer when the washer reservoir is empty.

This may cause the washer pump to overheat.

Press the end of the stalk to activate the washer.

Press the end of the stalk to activate the washer.

• A brief press causes the wipers to swipe three times with washer fluid.
• A long press and hold will activate the wipers and washer fluid for up to 10 seconds.

A wipe will occur a few seconds after washing to clear any remaining washer fluid. This feature can be turned on and off in the information display.

    See also:

    Safety belt height adjustment
    WARNING: Position the safety belt height adjusters so that the belt rests across the middle of your shoulder. Failure to adjust the safety belt properly could reduce the effectiveness of the seat ...

    MyFord Touch® (If Equipped)
    INTRODUCTION WARNING: Driving while distracted can result in loss of vehicle control, crash and injury. We strongly recommend that you use extreme caution when using any device that may take your ...

    General audio information
    Radio frequencies: AM and FM frequencies are established by the Federal Communications Commission (FCC) and the Canadian Radio and Telecommunications Commission (CRTC). Those frequencies are: AM ...