Identifying your vehicle
Safety Compliance Certification Label
The National Highway Traffic Safety Administration Regulations require that a Safety Compliance Certification Label be affixed to a vehicle and prescribe where the Safety Compliance Certification Label may be located. The Safety Compliance Certification Label is located on the structure (B-Pillar) by the trailing edge of the driver’s door or the edge of the driver’s door.
Vehicle identification number (VIN)
The vehicle identification number is located on the driver side instrument panel.
Please note that in the graphic, XXXX is representative of your vehicle identification number.
The Vehicle Identification Number (VIN) contains the following information:
1. World manufacturer identifier
2. Brake system / Gross Vehicle
Weight Rating (GVWR) / Restraint
Devices and their location
3. Make, vehicle line, series, body type
4. Engine type
5. Check digit
6. Model year
7. Assembly plant
8. Production sequence number
See also:
Electronic compass (if equipped)
The compass heading is displayed in the center stack display.
The compass reading may be affected when you drive near large buildings, bridges,
power lines and powerful broadcast antenna. Magnetic ...
Navigation system
Note: The navigation SD card must be in the SD card slot to operate the
navigation system. If you need a replacement SD card, see your authorized dealer.
Note: The SD card slot is spring-loaded. To ...
Driving through water
If driving through deep or standing water is unavoidable, proceed very slowly.
Never drive through water that is higher than the bottom of the wheel rims (for
cars) or the bottom of the hubs (for ...