Hazard warning flashers

The hazard flasher control is located on the instrument panel by the radio. Use

The hazard flasher control is located on the instrument panel by the radio. Use it when your vehicle is disabled and is creating a safety hazard for other motorist.

• Press the flasher control and all front and rear direction signals will flash.
• Press the flasher control again to turn them off.

Note: With extended use, the flasher may run down your battery.

Vehicles equipped with MyTouch

• Press and hold the flasher control and all front and rear direction signals will flash.
• Press and hold the flasher control again to turn them off.

Note: With extended use, the flasher may run down your battery.

    See also:

    Vehicle certification label
    The National Highway Traffic Safety Administration Regulations require that a Safety Compliance Certification Label be affixed to a vehicle and prescribe where the Safety Compliance Certificatio ...

    Reporting safety defects (U.S. only)
    If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) i ...

    Warning lamps and indicators
    These lights can alert you to a vehicle condition that may become serious enough to cause expensive repairs. Many lights will illuminate when you start your vehicle to make sure they work. If any ...