Interior mirror
The interior rearview mirror has two pivot points on the support arm which lets you adjust the mirror up or down and from side to side.
WARNING:
Do not adjust the mirror while the vehicle is in motion.
Automatic dimming interior rear view mirror (if equipped)
The interior rear view mirror has an auto-dimming function. The electronic day/night mirror will change from the normal (high reflective) state to the non-glare (darkened) state when bright lights (glare) reach the mirror. When the mirror detects bright light from behind the vehicle, it will automatically adjust (darken) to minimize glare.
The mirror will automatically return to the normal state whenever the vehicle is placed in R (Reverse) to ensure a bright clear view when backing up.
Do not block the sensors on the front and back of the interior rear view mirror since this may impair proper mirror performance.
Note: A rear center passenger and/or raised rear center headrest (if equipped) may also block the light from reaching the sensor.
Do not clean the housing or glass of any mirror with harsh abrasives, fuel or other petroleum-based cleaning products.
Note: If equipped with a rearview camera system, a video image will display in the mirror or the navigation system display (if equipped) when the vehicle is put in R (Reverse). As you shift into any other gear from R (Reverse), the image will remain for a few seconds and then turn off.
Refer to Rearview camera system in the Driving chapter.
See also:
Adjusting the headlamps
The headlamps on your vehicle are properly aimed at the assembly plant.
If your vehicle has been in an accident, the alignment of your headlamps should
be checked by your authorized dealer.
Vertic ...
Safety belt warning light and indicator chime
This lamp illuminates and an audible warning will sound if the driver’s safety
belt has not been fastened when the vehicle’s ignition is turned on.
Conditions of Operation
...
Fastening the safety belts
The front outboard and rear safety restraints in your vehicle are combination
lap and shoulder belts.
1. Insert the belt tongue into the proper buckle (the buckle closest to the direction
the t ...