Rear-window wiper and washer

Rotate the control to select:

Rotate the control to select:

2 — Intermittent operation (shortest pause between wipes).
1 — Intermittent operation (longest pause between wipes).
0 — Off.

Rotate and hold the control to either the top or bottom position to activate the rear washer. The control will return to the 2 or 0 position when you release it.

When you select reverse gear, the rear wiper will switch on to intermittent if the front wipers are activated. This feature may be enabled or disabled in the information display.

    See also:

    SecuriCode™ keyless entry keypad
    The keypad, located near the driver window, is invisible until touched and then it lights up so you can see and touch the appropriate buttons. Note: If you enter your entry code too fast on the key ...

    Ignition switch
    Note: Do not store the key in the ignition after the vehicle is turned off and you have left the vehicle. This could cause a drain on the battery. Note: In order to switch off the engine while the ...

    Changing a road wheel
    WARNING: The use of tire sealants may damage your tire pressure monitoring system and should not be used. However, if you must use a sealant, the tire pressure monitoring system sensor and valve s ...