Windshield washers

Note: Do not operate the wipers on a dry windshield. This may scratch the glass, damage the wiper blades or cause the wiper motor to burn out.

Always use the windshield washer before wiping a dry windshield.

Note: Do not operate the washer when the washer reservoir is empty.

This may cause the washer pump to overheat.

Press the end of the stalk to activate the washer.

Press the end of the stalk to activate the washer.

• A brief press causes the wipers to swipe three times with washer fluid.
• A long press and hold will activate the wipers and washer fluid for up to 10 seconds.

A wipe will occur a few seconds after washing to clear any remaining washer fluid. This feature can be turned on and off in the information display.

    See also:

    Hazard Flasher Control
    The hazard flasher is located on the steering column, just behind the steering wheel. The hazard flashers will operate when the ignition is in any position or if the key is not in the ignition. â ...

    Fuel consumption
    Filling the Tank The advertised capacity is the indicated capacity and the empty reserve combined. Indicated capacity is the difference in the amount of fuel in a full tank and a tank when the fu ...

    Active park assist
    WARNING: This system is designed to be a supplementary park aid. It may not work in all conditions and is not intended to replace the driver’s attention and judgment. The driver is responsible f ...