Washer fluid check
WARNING: If you operate your vehicle in temperatures below 40°F (5°C), use washer fluid with antifreeze protection. Failure to use washer fluid with antifreeze protection in cold weather could result in impaired windshield vision and increase the risk of injury or accident.
Add fluid to fill the reservoir if the level is low. Only use a washer fluid that meets Ford specifications. See the technical specifications chart in the Capacities and Specifications chapter.
Note: The front and rear washer systems are supplied from the same reservoir.
State or local regulations on volatile organic compounds may restrict the use of methanol, a common windshield washer antifreeze additive.
Washer fluids containing non-methanol antifreeze agents should be used only if they provide cold weather protection without damaging the vehicle’s paint finish, wiper blades or washer system.
See also:
Checking the wiper blades
Run the tip of your fingers over the edge of the blade to check for roughness.
Clean the wiper blades with washer fluid or water applied with a soft sponge
or cloth.
CHANGING THE WIPER BLADES
...
Ignition switch
Note: Do not store the key in the ignition after the vehicle is turned
off and you have left the vehicle. This could cause a drain on the battery.
Note: In order to switch off the engine while the ...
Fuses
Changing a fuse
WARNING: Always replace a fuse with one that has the specified amperage
rating. Using a fuse with a higher amperage rating can cause severe wire damage
and could start a fire.
...