Hazard warning flashers

The hazard flasher control is located on the instrument panel by the radio. Use

The hazard flasher control is located on the instrument panel by the radio. Use it when your vehicle is disabled and is creating a safety hazard for other motorists.

• Press the flasher control and all front and rear direction signals will flash.
• Press the flasher control again to turn them off.

Note: With extended use, the flashers may run down your 12 volt battery.

    See also:

    Securilock passive anti-theft system
    SecuriLock passive anti-theft system is an engine immobilization system. This system is designed to help prevent the engine from being started unless a coded integrated keyhead transmitter (IKT) p ...

    Information contained on the tire sidewall
    Both U.S. and Canada Federal regulations require tire manufacturers to place standardized information on the sidewall of all tires. This information identifies and describes the fundamental charac ...

    General information on radio frequencies
    This device complies with part 15 of the FCC Rules and with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause harm ...