Panel dimmer control

Use to adjust the brightness of the instrument panel and all applicable switches in the vehicle during headlamp and parking lamp operation.

• Move the control to the full upright position, past detent, to turn on the interior lamps.
• Rotate to full down position (past detent) to prevent interior lamps from illuminating when the doors are opened.

discharged, or a new battery is installed, the dimmer switch requires re-calibration. Note: If the battery is disconnected, discharged, or a new battery is installed, the dimmer switch requires re-calibration. Rotate the dimmer switch from the full dim position to the full dome/on position to reset.

This will ensure that your displays are visible under all lighting conditions.

    See also:

    Breaking-in your vehicle
    Your vehicle does not need an extensive break-in. Try not to drive continuously at the same speed for the first 1,000 miles (1,600 km) of new vehicle operation. Vary your speed frequently in order ...

    Checking the wiper blades
    Run the tip of your fingers over the edge of the blade to check for roughness. Clean the wiper blades with washer fluid or water applied with a soft sponge or cloth. ...

    General maintenance information
    Why Maintain Your Vehicle? Carefully following the maintenance schedule helps protect against major repair expenses resulting from neglect or inadequate maintenance and may also help to increase ...