Engine oil check
Note: Check the level before starting the engine.
Note: Make sure that the level is between the MIN and MAX marks.
1. Make sure that your vehicle is on level ground.
2. Turn the engine off and wait 10 minutes for the oil to drain into the oil pan.
3. Remove the dipstick and wipe it with a clean, lint-free cloth. Replace the dipstick
and remove it again to check the oil level.
If the level is at the MIN mark, add oil immediately.
Adding Engine Oil
Note: Do not remove the filler cap when the engine is running.
Note: Do not add engine oil further than the MAX mark. Oil levels above the MAX mark may cause engine damage.
Only use oils certified for gasoline engines by the American Petroleum Institute (API). An oil with this trademark symbol conforms to the current engine and emission system protection standards and fuel economy requirements of the International Lubricants Specification Advisory Council (ILSAC), comprised of U.S. and Japanese automobile manufacturers.
1. Remove the filler cap.
2. Add engine oil that meets Ford specifications. See Capacities and Specifications
for more information.
3. Replace the filler cap. Turn it until you feel a strong resistance.
See also:
Hazard warning flashers
The hazard flasher control is located on the instrument panel by the radio. Use
it when your vehicle is disabled and is creating a safety hazard for other motorist.
• Press the flasher control ...
System status
The information display controls provide information about keys programmed to
the vehicle:
• MYKEY MILES: Tracks mileage when a MyKey is used. If mileage does not
accumulate as expected, then t ...
Economical driving
Fuel economy is affected by several things, such as how you drive, the conditions
you drive under and how you maintain your vehicle.
There are some things to keep in mind that may improve your fuel ...