Brakes
GENERAL INFORMATION
Note: Occasional brake noise is normal. If a metal-to-metal, continuous grinding or continuous squeal sound is present, the brake linings may be worn out and should be inspected by an authorized dealer. If your vehicle has continuous vibration or shudder in the steering wheel while braking, you should take it to an authorized dealer for inspection.
Note: Brake dust may accumulate on the wheels, even under normal driving conditions. Some dust is inevitable as the brakes wear and does not contribute to brake noise. See the Vehicle Care chapter for wheel cleaning instructions.
See the Instrument Cluster chapter for information on the brake system warning light.
Wet brakes result in reduced braking efficiency. Gently press the brake pedal a few times when driving from a car wash or standing water to dry the brakes.
Brake Over Accelerator
If the accelerator pedal becomes stuck or entrapped, apply steady and firm pressure to the brake pedal to slow your vehicle and reduce engine power. If you experience this condition, apply the brakes and bring your vehicle to a safe stop. Turn the engine off, shift to position P and apply the parking brake, then inspect the accelerator pedal for any interferences. If none are found and the condition persists, have your vehicle towed to the nearest authorized dealer.
Brake Assist
Brake assist detects when you brake heavily by measuring the rate at which you press the brake pedal. It provides maximum braking efficiency as long as you press the pedal. Brake assist can reduce stopping distances in critical situations.
Anti-Lock Brake System
This system helps you maintain steering control during emergency stops by keeping the brakes from locking.
The anti-lock brake system lamp momentarily illuminates when the ignition is turned on. If the light does not illuminate during start-up, remains on or flashes, the anti-lock brake system may be disabled and may need to be serviced.
If the anti-lock brake system is disabled, normal braking is still effective. If the brake warning lamp illuminates with the parking brake released, have your brake system serviced immediately.
See also:
Driving Aids
Blind Spot Information System (BLIS) with Cross Traffic Alert(CTA)
WARNING: To help avoid injuries, NEVER use the BLIS® as a replacement
for using the interior and exterior mirrors and looking ...
Headlamp exit delay
You can set the delay time to keep the headlamps on for up to three minutes after
the ignition is turned off.
Follow the steps below to change the delay time (Steps 1 through 6 must be done
withi ...
Information contained on the tire sidewall
Both U.S. and Canada Federal regulations require tire manufacturers to place
standardized information on the sidewall of all tires. This information identifies
and describes the fundamental charac ...