Creating
Use the information display to create a MyKey.
1. Insert the key you want to program into the ignition. With a push-button start
(if equipped), put the Intelligent Access key in the backup slot; see the Starting
and Stopping the Engine chapter for the backup slot location
.
2. Turn the ignition on.
3. From the main menu within the information display, press OK or the> button
to navigate through the various screens. Select Settings and then MyKey.
4. Press OK or the> to select Create.
5. When prompted, hold the OK button until you see a message informing you
to label this key as a MyKey. The key will be restricted at your vehicle’s next
start.
After the key is successfully programmed, make sure you label it so you can distinguish it from the admin keys.
You can also program optional settings for the key(s). Refer to Programming/Changing Optional Settings.
Programming/Changing Optional Settings
Note: All programmed keys can be cleared within the same key cycle in which a key was programmed, otherwise an admin key is required to clear the keys. To clear all keys, refer to Clearing all MyKeys.
You can access the optional settings through the information display control.
1. Turn the ignition on using an admin key.
2. Access the main menu and select Settings, then MyKey.
3. Use the arrow buttons to get to an optional feature.
4. Press OK or > to scroll through settings.
5. Press OK or > to make a selection.
See also:
Engine oil check
Note: Check the level before starting the engine.
Note: Make sure that the level is between the MIN and MAX marks.
1. Make sure that your vehicle is on level ground.
2. Turn the engine off and wait ...
Hazard Flasher Control
The hazard flasher is located on the steering column, just behind the steering
wheel. The hazard flashers will operate when the ignition is in any position or
if the key is not in the ignition.
â ...
Safety Belt System
WARNING:
Always drive and ride with your seatback upright and the lap belt snug and low across
the hips.
WARNING:
To reduce the risk of injury, make sure children sit where they can be proper ...