Windshield washers

Note: Do not operate the wipers on a dry windshield. This may scratch the glass, damage the wiper blades or cause the wiper motor to burn out.

Always use the windshield washer before wiping a dry windshield.

Note: Do not operate the washer when the washer reservoir is empty.

This may cause the washer pump to overheat.

Press the end of the stalk to activate the washer.

Press the end of the stalk to activate the washer.

• A brief press causes the wipers to swipe three times with washer fluid.
• A long press and hold will activate the wipers and washer fluid for up to 10 seconds.

A wipe will occur a few seconds after washing to clear any remaining washer fluid. This feature can be turned on and off in the information display.

    See also:

    Safety Belt System
    WARNING: Always drive and ride with your seatback upright and the lap belt snug and low across the hips. WARNING: To reduce the risk of injury, make sure children sit where they can be proper ...

    Hill descent control
    WARNING: Hill descent control cannot control descent in all surface conditions and circumstances, such as ice or extremely steep grades. Hill descent control is a driver assist system and cannot s ...

    Audible warnings and indicators
    Key In Ignition Warning Chime Sounds when the key is left in the ignition in the off or accessory position and the driver’s door is opened. Keyless Warning Alert (If Equipped) Sounds when the k ...